Home Addition Drywall in Toronto
Your Toronto addition has to line up with the rooms you already live in. P.L.R Drywall hangs the new board to meet them.
Or email patleroy6161@gmail.com

Old ceiling, new ceiling, one line
Where the addition joins your house, the new board often has to meet an existing wall or ceiling. We cut and fit each sheet to that edge, and fasten it to framing that may not be perfectly straight. Screws sit just below the paper face without tearing it.
Toronto Building approvals for your addition
If your project has a permit from the City of Toronto, we hang to the approved drawings. That includes jobs in Scarborough and North York, which are part of the city.
Within Toronto
Home Addition Drywall in other areas
Home Addition Drywall in Toronto: questions
Does the insulation in the addition need inspecting before board goes up?
Where a building permit applies, work done before board, such as insulation and vapour barrier, may need inspection before it is covered. Check what your permit requires before the hang goes ahead.
What has to be done in the addition before you can hang?
Board usually goes up once the addition is closed in, the framing is done, the plumbing, electrical and ductwork rough-ins are in, and the insulation and vapour barrier are installed.
Can you board a dividing wall inside the new addition?
A partition wall is a non-load-bearing wall that divides a space, and it is usually boarded on both sides. Partition Wall Drywall is one of our services, and it applies inside an addition.
What details should I send when asking about my addition?
Tell us about the ceilings, any tall windows or arches, and where the addition meets the house. If there are approved permit drawings, mention that too, since we hang to them.
Book an on-site quote
Calling is fastest:
(365) 499-0040Email: patleroy6161@gmail.com
Or send the form with the rooms, ceiling heights and timing. Quotes are given on site, so we will arrange a visit.
We install the drywall only. The board is supplied by others, and taping and finishing are done by others.