P.L.R Drywall

Drywall Boarding

Boarding is the trade word for hanging drywall: fastening gypsum sheets to wall and ceiling framing with drywall screws.

Two installers on scaffold fastening drywall on a tall gable wall

About this service

On a build, boarding is one stage between trades. Framing, plumbing, electrical and ductwork rough-ins, insulation and vapour barrier come first. Where a building permit applies, that work may need inspection before board covers it.

We board ceilings first, then walls. Tall gable walls are boarded from scaffold. We keep joints few and stagger butt joints, which makes taping easier for whoever finishes the walls. If you are a builder planning the order of trades, tell us where boarding falls on your schedule.

What this covers

  • Gypsum board fastened to wall and ceiling framing with drywall screws
  • Ceilings hung before walls so wall sheets carry ceiling edges
  • Sheet layout that keeps joints few, with butt joints staggered
  • Tall walls, high ceilings and stairwells hung from scaffold
  • Screws set just below the paper face at the specified spacing

Drywall Boarding: questions

What does drywall boarding actually mean?

Boarding is another name for hanging. It means fastening gypsum board sheets to wall and ceiling framing with drywall screws. The board is cut, lifted and fastened in place. That is the work we do.

What has to be finished before boarding can start?

Board usually goes up after framing is done and plumbing, electrical and ductwork rough-ins are in. Insulation and vapour barrier also need to be in place before the board covers them.

Can you board a tall wall like a two-storey window wall?

Yes. Our past work includes a two-storey window wall, high and vaulted ceilings, skylight wells and stairwells, all hung from scaffold. Tall walls like these are hung from scaffold or lifts.

What is a staggered butt joint in boarding?

A butt joint is where two sheet ends meet. Staggering means those joints do not line up from one row of sheets to the next. Board is laid out that way rather than in a straight line.

Can you board a renovation next to old walls?

Yes. Renovation work often means hanging new board next to existing walls and ceilings. It also means fitting the board to framing that may not be perfectly straight.

What changes when boarding a fire-rated wall?

Fire-rated board, often called Type X, is commonly 5/8 inch thick. The rating belongs to the whole assembly, so the board is hung exactly as the drawings and the listed assembly specify.

Book an on-site quote

Calling is fastest:

(365) 499-0040

Or send the form with the rooms, ceiling heights and timing. Quotes are given on site, so we will arrange a visit.

We install the drywall only. The board is supplied by others, and taping and finishing are done by others.

Phone or email, at least one.