Drywall Boarding in Whitby
Your Whitby job is ours until the last sheet is fastened. After that, a taper takes over.
Or email patleroy6161@gmail.com

Where our part of the job ends
We hang the board and screw it to the framing. When the last sheet in your Whitby home is fastened, our part is done. Taping and finishing come next, and they are done by others. We do not tape, mud or finish.
A layout that makes taping easier
We plan sheets to keep joints few. Butt joints are staggered, not lined up. Fewer, better-placed joints make taping easier for whoever finishes the walls. We work this way in Brooklin as well.
Within Whitby
Whitby is part of
Drywall Boarding in other areas
Drywall Boarding in Whitby: questions
What has to be finished before boarding can start?
Board usually goes up after framing is done and plumbing, electrical and ductwork rough-ins are in. Insulation and vapour barrier also need to be in place before the board covers them.
Does insulation need an inspection before the board goes up?
Where a building permit applies, the work before board, such as insulation and vapour barrier, may need inspection before it is covered. If your project has a permit, we hang to the approved drawings.
How is an addition boarded where it meets the house?
The new space is hung, and the new board often has to meet existing walls or ceilings where the addition joins the house. That joining point is part of the hang.
Are there rules for boarding the wall between a garage and house?
In an attached garage, the wall and ceiling between the garage and the house are usually subject to building code requirements. The board is hung as the permit drawings specify.
Book an on-site quote
Calling is fastest:
(365) 499-0040Email: patleroy6161@gmail.com
Or send the form with the rooms, ceiling heights and timing. Quotes are given on site, so we will arrange a visit.
We install the drywall only. The board is supplied by others, and taping and finishing are done by others.