Drywall Boarding in Pickering
For builders and contractors in Pickering, boarding means one thing: gypsum board fastened to wall and ceiling framing with drywall screws.
Or email patleroy6161@gmail.com

Boarding and hanging are the same trade
Boarding is another name for hanging. On a Pickering job, we cut each sheet, lift it and fasten it to the framing with drywall screws. Ceilings usually go up before walls. The wall sheets then help carry the ceiling edges.
Steel stud screws for Pickering commercial boarding
Commercial interiors often use steel stud framing. There, the board is fastened with screws made for steel studs. Sheets are laid out to keep joints few, with butt joints staggered. Where there are drawings, we hang to them.
Pickering is part of
Drywall Boarding in other areas
Drywall Boarding in Pickering: questions
Does insulation need an inspection before the board goes up?
Where a building permit applies, the work before board, such as insulation and vapour barrier, may need inspection before it is covered. If your project has a permit, we hang to the approved drawings.
Where does boarding fit in a builder's schedule?
A builder or general contractor schedules the hang between other trades. It usually comes after rough-ins and insulation and before taping. We fit our boarding into that order on the job.
Can you board over steel stud framing?
Yes. Commercial interiors often use steel stud framing. Board is fastened to steel studs with screws made for steel studs rather than the screws used on wood framing.
What changes when boarding a fire-rated wall?
Fire-rated board, often called Type X, is commonly 5/8 inch thick. The rating belongs to the whole assembly, so the board is hung exactly as the drawings and the listed assembly specify.
Book an on-site quote
Calling is fastest:
(365) 499-0040Email: patleroy6161@gmail.com
Or send the form with the rooms, ceiling heights and timing. Quotes are given on site, so we will arrange a visit.
We install the drywall only. The board is supplied by others, and taping and finishing are done by others.