Ceiling Drywall Installation in Scarborough
On Scarborough jobs, we place ceiling joints with light in mind, setting out the board before any sheet is fastened.
Or email patleroy6161@gmail.com

Joints that light picks out up high
Joints on high ceilings are harder to reach and show more under light. On those ceilings, long sheets and careful layout matter more. We plan both before lifting the first sheet in Scarborough.
Screw depth that leaves paper intact
Ceilings go up before walls. Each screw is driven so the head sits just below the paper face without tearing it. Spacing follows what the board maker and drawings call for. Butt joints are staggered. Your taping trade gets fewer, better-placed joints to finish.
Scarborough is part of
Ceiling Drywall Installation in other areas
Ceiling Drywall Installation in Scarborough: questions
What has to be done before the ceiling board goes up?
Board usually goes up after framing, plumbing, electrical and ductwork rough-ins are in. Insulation and vapour barrier also go in before the board covers them.
Does the vapour barrier need inspection before the ceiling is covered?
Where a building permit applies, the work before board, such as insulation and vapour barrier, may need inspection before it is covered. If your project has a permit, we hang to the approved drawings.
Do you hang ceilings on steel stud framing in commercial spaces?
Commercial interiors often use steel framing. On steel, the board is fastened with screws made for steel studs, and the ceiling sheets are laid out to keep joints few.
How far apart are the screws on a ceiling?
Screws go in at the spacing that the board maker and the drawings call for. The head is set just below the paper face so the board stays held without the paper tearing.
Book an on-site quote
Calling is fastest:
(365) 499-0040Email: patleroy6161@gmail.com
Or send the form with the rooms, ceiling heights and timing. Quotes are given on site, so we will arrange a visit.
We install the drywall only. The board is supplied by others, and taping and finishing are done by others.