Drywall Hanging in Whitby
Before we hang a room in Whitby, the framing, rough-ins, insulation and vapour barrier need to be in place.
Or email patleroy6161@gmail.com

Board goes up after rough-ins and insulation
Board covers the wall and ceiling cavities. So it goes up after framing, and after the plumbing, electrical and ductwork rough-ins are done. Insulation and vapour barrier go in before the board as well. Once the board is up, those cavities are closed.
Tell us which trades are finished
When you call, let us know where the job stands. Tell us which of those trades are done and which are still to come. Whitby includes Brooklin, and we hang board in both.
Within Whitby
Whitby is part of
Drywall Hanging in other areas
Drywall Hanging in Whitby: questions
What is a staggered butt joint and why does it matter?
A butt joint is where two sheet ends meet. We stagger them rather than lining them up from row to row. Joints that are better placed are easier to tape than joints stacked into one long line.
How deep should drywall screws be driven into the board?
The screw head should sit just below the paper face without tearing it. A head left standing proud or driven through the paper causes trouble later, so each screw is set to that depth.
Do you hang drywall on steel stud framing?
Yes. Commercial interiors often use steel stud framing. On steel studs, the board is fastened with screws made for steel studs, driven to the same depth below the paper face.
What drywall goes on the garage wall shared with the house?
The wall and ceiling between an attached garage and the house are usually subject to building code requirements. We hang that board exactly as the permit drawings specify.
Book an on-site quote
Calling is fastest:
(365) 499-0040Email: patleroy6161@gmail.com
Or send the form with the rooms, ceiling heights and timing. Quotes are given on site, so we will arrange a visit.
We install the drywall only. The board is supplied by others, and taping and finishing are done by others.